EZY-COR is the most user friendly crown moulding
on the market today. Its ease of fixing adds to its
long list of advantages.
A sharp small tooth saw or knife edge tool is ideal. Power
mitre saws are also a handy option.
Walls should be measured accurately. Moulding
is cut in a mitre box, with the wall edge up. EZY-COR
has a degree of resilence which allows mitres to compress
and each mitre fits tight and neat every time.
A good quality adhesive with good filling qualities and
minimal shrinkage is required. Apply a bead of adhesive
to both wall and ceiling edges, and also mitre ends, then
place moulding into position, at the correct projection.
EZY-COR Firmly press into position ( no keeper nails are
The excess adhesive should squeeze out along the length
of the wall and ceiling junction and also mitres and joins.
By running a small broad knife or the square end of a
small tool along these edges, you will neatly remove the
excess adhesive. Then simply sponge off lightly with clean
water. Due to the characteristics of
EZY-COR the tightly fitting mitres are quick and easy
A good quality water based ceiling paint is recommended,
avoid build up of paint along members and in mitres. Paint
will crack in drying process if applied too thick. As
with most internal lining products, spray application
is not recommended.